- per page
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular brake pedal features a tig-welded three position tab that allows you to fine tune braking feel. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
Brake caliper shims can help you dial in how quickly your brake pads grab the brake rotor. These shims come in two different sizes, a 1/32" and a 1/16" allowing for easy changes with precise comfort.
These MCP Caliper Bleed Screw are the fast, easy alternative to getting your brakes bled. These screws work with the MCP Billet, Cast, and MiniLite braking systems.
This cast brake caliper from Martin Custom Products is used on most 4 cycle applications in modern Margay karts. This caliper assembly comes with everything you need to stop on a dime in no time.
These metallic brake pads are designed to be used with the MCP Cast Caliper system. They are easy to install and should help shed some tenths under braking.
This caliper rebuild kit is designed to rebuild the MCP Cast brake caliper system. It comes with two pistons, and 2 piston o-rings, and should help restore some stopping power in your old caliper.
This master cylinder filler cap is designed to be used with the MCP Cast master cylinder.
This master cylinder rebuild kit comes with everything you need to rebuild your MCP Cast master cylinder from the ground up. This kit should help increase the performance of your worn out master cylinder.
This 5/16 x 18 brake pad adjuster assembly is designed to be used with the MCP Cast caliper system. It allows you to help dial in the throw of you brake pedal by allowing the pads to grab quicker or slower than their current setting.
This complete braking system features the MCP Cast brake caliper and master cylinder. Looking to upgrade your stopping power or replace older parts? This kit gives you everything you need to do it.
Brake Kit Ships Pre-Bled
This MCP standard master cylinder assembly is all you need to replace your existing MCP master cylinder. This master cylinder is designed to be used with the MCP standard brake caliper. Piston Diameter: .875"
- #71301 features two brass fittings for use with 3/16” plastic line
- #7130 features a single outlet with a -3 AN fitting for use with a single braided line (as used on current Ignite karts)
- #71311 features dual -3 AN fittings for use with dual braided lines (as used pre-2018 Ignite karts)
The MCP standard system uses DOT 5 (Silicon) fluid which can be found here.
- per page
Bridgestone Tires-Sales & Closeouts
Accessories
Frame Components
OTK VLR100 Engines
