- per page
This master cylinder filler cap is designed to be used with the MCP Cast master cylinder.
These MCP Caliper Bleed Screw are the fast, easy alternative to getting your brakes bled. These screws work with the MCP Billet, Cast, and MiniLite braking systems.
Brake caliper shims can help you dial in how quickly your brake pads grab the brake rotor. These shims come in two different sizes, a 1/32" and a 1/16" allowing for easy changes with precise comfort.
For use on all Margay Brava or other Euro style karts. Standard equipment on all Brava karts. Small barrel on cable end fits OE Yamaha carb swivels. This cable is not well suited for use on older (Pre-1997) Margay karts that use a control rod and cable pull adapter (which utilizes the 54" throttle cable).
This 5/16 x 18 brake pad adjuster assembly is designed to be used with the MCP Cast caliper system. It allows you to help dial in the throw of you brake pedal by allowing the pads to grab quicker or slower than their current setting.
This master cylinder rebuild kit comes with everything you need to rebuild your MCP Cast master cylinder from the ground up. This kit should help increase the performance of your worn out master cylinder.
This caliper rebuild kit is designed to rebuild the MCP Cast brake caliper system. It comes with two pistons, and 2 piston o-rings, and should help restore some stopping power in your old caliper.
These metallic brake pads are designed to be used with the MCP Cast Caliper system. They are easy to install and should help shed some tenths under braking.
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular brake pedal features a tig-welded three position tab that allows you to fine tune braking feel. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular throttle pedal is tig-welded and is finished with nickel plating. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
- per page