- per page
The Margay Racing Brava 25mm spindle are key when running high horsepower karting packages. They allow more adjust-ability as well as more overall front end grip. These spindles help prevent under steer, and help get you into the winners circle.
Need some extra front end grip? Adding 25mm spindles in place of the standard 17mm spindles is the answer. Machined from billet 86L20 steel then heat-treated to our specifications, our 25mm spindles significantly increase initial turn-in response and overall front grip. A must have for higher horsepower applications.
These spindle spacers are designed to be used with 25mm spindle shafts. They come in a 5mm length and a 15mm length. Most modern applications use three of each per spindle.
These spindle spacers are used to adjust the ride height of the spindle. These shims are 1/8" thick and are designed to be used with a 3/8" kingpin bolt. Most modern day applications require four spacers per side.
Margay Racing's new billet aluminium steering block fairing mount combines cutting edge technology with lightweight performance. This steering block is available for American manufactures (3/4") and European manufactures (20mm).
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. Steering wheel mounting holes are tapped for M6x1 fasteners.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
These front hubs are designed to be used with 25mm spindle shafts. They can help add some track width to the front end, giving your chassis more front end entry grip. They come in two sizes: medium and long as well as two colors: red and silver.
Bearings used in the 25mm aluminum and magnesium wheels hubs, non-ceramic.
37mm OD
7mm wide
Bearings used in the 17 mm aluminum and magnesium wheels, non-ceramic.
This kingpin bearing has a 3/8" diameter and is designed to work with all modern day spindles, along with the older style 10, 12, and 15 degree vintage spindles.
Voltz clips are used for various applications around the kart. Bigger clips are usually used on the end of the spindles, and smaller clips are usually used on the kingpin ends.
- per page