- per page
This steering shaft is designed to be used with the 5/8" solid steering shafts on the older vintage style Margay chassis.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
The 5/8" diameter solid steering shafts were typically used on all Margay karts built before 1994. They feature 2 position steering ackerman adjust-ability.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
These 1 3/4" bearing cassettes are designed to be used with any modern Margay 3 bolt bearing hanger and 1 3/4" bearings only.
This 40mm wheel hub is manufactured from billet aluminum and is layed out in a 3.58 'Euro' mount pattern. It features a pilot lip on the end of the hub that is removable if you need to go narrower on the axle. 65mm in length.
These split bearing cassettes are for the use of 40mm or 50mm axle bearings in the older 3 bolt cassette mounting chassis. They are split at the top to provide adjustable tension on the bearing itself.
This 30mm brake hub is super light weight, and provides a slick red or black look. It is designed to be used with the MCP 6.0" 3-bolt brake rotor.
This 1 3/8 axle measures a full 40" in length. It is designed to be used with the 1 3/8" bearing cassettes and 1 3/8" bearings.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
This 1 1/4" TruSpeed sprocket hub is super light-weight and has a slick flat black finish. It is designed to be used only with a 1 1/4" axle and a 6 bolt gear.
This 9 1/4" front torsion tube is made to increase chassis stiffness in the Brava Rookie models. When inserted, the front end becomes more rigid allowing for increase front end grip levels.
Need some rear end grip, but don't want to go over the top? Then this rear torsion blade is for you. Inserted into a Brava 1.25 chassis, this torsion blade can be adjusted to a soft or hard setting to help give the precise grip levels that you are needing.
Made for direct use with the Margay Brava 1.25 chassis, this rear torsion tube will help provide a strong level of grip to the rear end of the kart.
This 12" long rear torsion tube is made to be used in the Brava 1.2 and later models. It will help increase the rear grip levels by providing a stiffer rear end.
- per page