- per page
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
This 30mm brake hub is super light weight, and provides a slick red or black look. It is designed to be used with the MCP 6.0" 3-bolt brake rotor.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
The 5/8" diameter solid steering shafts were typically used on all Margay karts built before 1994. They feature 2 position steering ackerman adjust-ability.
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular brake pedal features a tig-welded three position tab that allows you to fine tune braking feel. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular throttle pedal is tig-welded and is finished with nickel plating. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
This front bumper can only be used with the Margay Racing designed Shifter chassis. This is a closeout item and will not be manufactured again once our stock is gone.
This 40mm wheel hub is manufactured from billet aluminum and is layed out in a 3.58 'Euro' mount pattern. It features a pilot lip on the end of the hub that is removable if you need to go narrower on the axle. 65mm in length.
This floor pan is made for use with the 2001 Brava Cadet racing chassis and comes in a flat black finish.
This 1 1/4" TruSpeed sprocket hub is super light-weight and has a slick flat black finish. It is designed to be used only with a 1 1/4" axle and a 6 bolt gear.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
These nerf bars are designed to be used with pre 2003 Margay cadet karts with an angled front and rear mount tube.
- per page