- per page
We found another stash of axle nuts! This could be the last of them. Don't waste any time!
NOS 3/4-16 castle nuts for Margay series 150 axles that were standard equipment in all Margay karts produced from the late 1960's through 1980.
Sold in pairs.
These 20mm steering bushings are designed to be used with the 20mm kid kart style steering shafts. They are a rigid silver plastic and are very lightweight, and feature two mounting positions for extra adjust-ability.
Need some extra front end grip? Adding 25mm spindles in place of the standard 17mm spindles is the answer. Machined from billet 86L20 steel then heat-treated to our specifications, our 25mm spindles significantly increase initial turn-in response and overall front grip. A must have for higher horsepower applications.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
Adjustable Caster pill, 3/8 kingpin, full offset-Utilize to change caster and camber on all AC compatible spindle hangers that feature a 3/4" mounting hole. Installing a single pill allows you to change caster or camber by up to 1.5 degrees. Installing a full offset pill in the top and bottom of the sppindle hanger allows you to change caster by up to 3 degrees.
This floor pan is used in all Brava Limo chassis. They are 27 5/8" long and 16 3/4" wide, in a flat black finish. This floor pan will fit Brava 1, 1.2, 1.4, 1.6, 1.7, 1.8, 1.9, 1.10, and 1.11 racing chassis.
This torsion blade is made for the new style Margay racing chassis and provide a great level of grip options to the front end of the kart. It can be set in a soft or hard position to help dial in the front end handling of the kart. They are manufactured from billet aluminium.
This KG Bodyworks steering wheel has a 11 3/4" diameter and is wrapped completely in suede. It has a black anodized center aluminium piece holding it all together. This wheel is designed to be used with cadet / rookie karts.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
This 3/8" bearing 17mm billet spindle assembly comes with everything you need to replace the left spindle on your Brava chassis. It comes complete with the spindle, tie rod end with hardware, wheel spacers, castle nut and safety clip. This package should have what you need to get you rolling again.
- per page