- per page
The Brava Cadet/Rookie floor pan is made for use with all chassis models that are 2003 and newer. They are 22 1/8" long and 14 5/8" wide and in a flat black finish.
This floor pan is used in all standard Brava, non-limo, chassis. They are 26" long and 16 3/4" wide, in a flat black finish. This floor pan will fit Brava 1, 1.2, 1.4, 1.6, 1.7, 1.8, 1.9, 1.10, and 1.11 racing chassis.
This floor pan is used in all Brava Limo chassis. They are 27 5/8" long and 16 3/4" wide, in a flat black finish. This floor pan will fit Brava 1, 1.2, 1.4, 1.6, 1.7, 1.8, 1.9, 1.10, and 1.11 racing chassis.
This flat black floor pan is made to be used with the vintage Margay Syncro Blade chassis. The two holes in the floor pan are to provide clearance for the front torsion bar clamps.
For use on 1992-2000 model year karts that feature angled nerf bar mount tubes. These nerfs were utilized for extra protection when running rear widths of 50" or wider. Sold Individually.
These nerf bars are designed to be used with pre 2003 Margay cadet karts with an angled front and rear mount tube.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
This 1 1/4" TruSpeed sprocket hub is super light-weight and has a slick flat black finish. It is designed to be used only with a 1 1/4" axle and a 6 bolt gear.
This floor pan is made for use with the 2001 Brava Cadet racing chassis and comes in a flat black finish.
This 40mm wheel hub is manufactured from billet aluminum and is layed out in a 3.58 'Euro' mount pattern. It features a pilot lip on the end of the hub that is removable if you need to go narrower on the axle. 65mm in length.
This front bumper can only be used with the Margay Racing designed Shifter chassis. This is a closeout item and will not be manufactured again once our stock is gone.
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular brake pedal features a tig-welded three position tab that allows you to fine tune braking feel. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
- per page