- per page
This is the hardware kit required to fasten the LO206 chain guard to the stock Briggs side cover. This kit comes with 2 BHCS bolts and two locking washers.
This clutch bolt kit is for use on the Briggs LO206 engine package and comes with: 5/16" bolt, 5/16" locking washer and a flat washer.
Rubber float bowl gasket for the Briggs LO206 Engine.
Briggs LO206 rules state that you have to run am exhaust gasket, so why not get the most durable one around? This copper head gasket will withstand the vibration and keep you on the track longer.
Keep your Briggs LO206 #5107 header and #4104 silencer securely fastened with this stainless steel silencer clamp.
This kit comes with all the bolts required to fasten your header to top of the cylinder head. Kit includes: 2 - M6 x 1 header bolts, 2 locking washers, two standard washers and safety wire to tie it all together.
Idle mix kit for the Briggs & Stratton LO206 engine.
Throttle return spring for the Briggs & Stratton LO206 carburator slide assembly.
This vent tube kit plugs directly into the hole in the valve cover and is designed to route the excess oil flow from the head, into an acceptable catch can system.
The LO206 engine requires air to pressurize the fuel pump. This is achieved by running a line from the crank case to the top of the fuel pump (marked 'P'). This crank case fitting replaces the yellow oil fill plug on the top of the engine and allows the pump to get it's needed pressure.
New for 2020 - The Autolite AR3910X is the required spark plug for all Briggs 206 engines.
Help keep your engine free of dirt and dust with this pre filter from Outerwear. This cover is to be used with the LO206 'Green' air filter, Briggs #555729. Check your local rules for legality.
- per page