- per page
These 20mm steering hubs are designed to be used with the 20mm kid kart steering shaft. Made from billet aluminium, these black anodized steering hubs have two mounting positions for optimum comfort.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.
Adjustable Caster pill, 3/8 kingpin, half offset-Utilize to change caster and camber on all AC compatible spindle hangers that feature a 3/4" mounting hole. Installing a single pill allows you to change caster or camber by up to .75 degrees. Installing a half offset pill in the top and bottom of the sppindle hanger allows you to change caster by up to 1.5 degrees.
The Brava Cadet/Rookie floor pan is made for use with all chassis models that are 2003 and newer. They are 22 1/8" long and 14 5/8" wide and in a flat black finish.
Made for direct use with the Margay Brava 1.25 chassis, this rear torsion tube will help provide a strong level of grip to the rear end of the kart.
Standard throttle cable used on all karts that utilize a 1/4" rod link to the pedal. Standard equipment on all Pre-1997 Margay karts and also on most oval track karts.
Clamp block for underside of the Wildcat/C1/Ignite K3 pedal clamp block assembly.
This 3/8" bearing 17mm billet spindle assembly comes with everything you need to replace the left spindle on your Brava chassis. It comes complete with the spindle, tie rod end with hardware, wheel spacers, castle nut and safety clip. This package should have what you need to get you rolling again.
These 20mm steering bushings are designed to be used with the 20mm kid kart style steering shafts. They are a rigid silver plastic and are very lightweight, and feature two mounting positions for extra adjust-ability.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
This floor pan is used in all Brava Limo chassis. They are 27 5/8" long and 16 3/4" wide, in a flat black finish. This floor pan will fit Brava 1, 1.2, 1.4, 1.6, 1.7, 1.8, 1.9, 1.10, and 1.11 racing chassis.
- per page
Bridgestone Tires-Sales & Closeouts
Accessories
Frame Components
OTK VLR100 Engines
