- per page
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. Steering wheel mounting holes are tapped for M6x1 fasteners.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
This 30mm brake hub is super light weight, and provides a slick red or black look. It is designed to be used with the MCP 6.0" 3-bolt brake rotor.
These split bearing cassettes are for the use of 40mm or 50mm axle bearings in the older 3 bolt cassette mounting chassis. They are split at the top to provide adjustable tension on the bearing itself.
This 40mm wheel hub is manufactured from billet aluminum and is layed out in a 3.58 'Euro' mount pattern. It features a pilot lip on the end of the hub that is removable if you need to go narrower on the axle. 65mm in length.
Front wheel hubs for the vintage style 5/8" spindles for US bolt pattern wheels. These hubs come with the mounting hardware to bolt the wheel to the hub.
The 5/8" diameter solid steering shafts were typically used on all Margay karts built before 1994. They feature 2 position steering ackerman adjust-ability.
These 5/8" Steering bushings are designed to be used with any size of the 5/8" tubular steering shafts. They are a rigid black plastic and are very lightweight.
This steering shaft is designed to be used with the 5/8" solid steering shafts on the older vintage style Margay chassis.
AC dowel pin, 3/16" x 1/2" for locating adjustable caster/camber pills. Standard equipment on all A/C karts built prior to 1994.
Adjustable Caster pill, 3/8 kingpin, full offset-Utilize to change caster and camber on all AC compatible spindle hangers that feature a 3/4" mounting hole. Installing a single pill allows you to change caster or camber by up to 1.5 degrees. Installing a full offset pill in the top and bottom of the sppindle hanger allows you to change caster by up to 3 degrees.
Adjustable Caster pill, 3/8 kingpin, half offset-Utilize to change caster and camber on all AC compatible spindle hangers that feature a 3/4" mounting hole. Installing a single pill allows you to change caster or camber by up to .75 degrees. Installing a half offset pill in the top and bottom of the sppindle hanger allows you to change caster by up to 1.5 degrees.
Adjustable caster / camber pill that allows the spindle to sit at its factory settings. These pills are centered, and can only be used with a 3/8" kingpin bolt.
Adjustable caster / camber pill that allows the spindle to sit at its factory settings. These pills are centered, and can only be used with a 8mm kingpin bolt.
- per page