- per page
These split bearing cassettes are for the use of 40mm or 50mm axle bearings in the older 3 bolt cassette mounting chassis. They are split at the top to provide adjustable tension on the bearing itself.
This 40mm wheel hub is manufactured from billet aluminum and is layed out in a 3.58 'Euro' mount pattern. It features a pilot lip on the end of the hub that is removable if you need to go narrower on the axle. 65mm in length.
These 1 3/4" bearing cassettes are designed to be used with any modern Margay 3 bolt bearing hanger and 1 3/4" bearings only.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
The 5/8" diameter solid steering shafts were typically used on all Margay karts built before 1994. They feature 2 position steering ackerman adjust-ability.
This 3/4" diameter tubular steering shafts are used on the more modern Margay chassis. They feature 3 position steering ackerman with a center hole and outside holes.
This steering shaft is designed to be used with the 5/8" solid steering shafts on the older vintage style Margay chassis.
These 20mm steering hubs are designed to be used with the 20mm kid kart steering shaft. Made from billet aluminium, these black anodized steering hubs have two mounting positions for optimum comfort.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. Steering wheel mounting holes are tapped for M6x1 fasteners.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.
This piece is to be used with the KG Bodyworks Daytona 330 series steering wheel, and is designed to be able to mount a Mychron or KG gauge.
This KG Bodyworks steering wheel has a 9 1/2" diameter and is wrapped completely in suede. It has a black anodized center aluminum piece holding it all together. This wheel is designed to be used with cadet / rookie karts.
These 5/8" Steering bushings are designed to be used with any size of the 5/8" tubular steering shafts. They are a rigid black plastic and are very lightweight.
These 3/4" Steering bushings are designed to be used with any size of the 3/4" tubular steering shafts. They are a rigid black plastic and are very lightweight.
- per page