- per page
Fabricated from 1/2" diameter 4130 Chromoly steel, our tubular throttle pedal is tig-welded and is finished with nickel plating. Mount bushing is sized for 5/16" hardware and can be drilled to accept the 3/8" hardware that was utilized on earlier model Brava karts. Mounting hardware is not included.
The 5/8" diameter solid steering shafts were typically used on all Margay karts built before 1994. They feature 2 position steering ackerman adjust-ability.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
This 30mm brake hub is super light weight, and provides a slick red or black look. It is designed to be used with the MCP 6.0" 3-bolt brake rotor.
This brake hub designed to be used with a 6 bolt brake rotor on an 1 3/4" axle. It is in a brilliant purple anodized finish and is manufacture from billet aluminum.
These 1 3/4" bearing cassettes are designed to be used with any modern Margay 3 bolt bearing hanger and 1 3/4" bearings only.
These nerf bars are designed to work with the Margay Sprint Enduro chassis.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.
These split bearing cassettes are for the use of 40mm or 50mm axle bearings in the older 3 bolt cassette mounting chassis. They are split at the top to provide adjustable tension on the bearing itself.
This front porch is an extension of the floor pan for Margay Enduro chassis that help keep the airflow underneath the chassis, allowing for the fastest straight line speeds possible.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. Steering wheel mounting holes are tapped for M6x1 fasteners.
- per page