- per page
This 3/8" bearing 17mm billet spindle assembly comes with everything you need to replace the right spindle on your Brava chassis. It comes complete with the spindle, tie rod end with hardware, wheel spacers, castle nut and safety clip. This package should have what you need to get you rolling again.
These 20mm steering hubs are designed to be used with the 20mm kid kart steering shaft. Made from billet aluminium, these black anodized steering hubs have two mounting positions for optimum comfort.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. The angled hub kicks the top of the wheel 8 degrees closer to the driver. Some drivers prefer a more vertically oriented wheel, claiming that it reduces fatigue and arm pump. Steering wheel mounting holes are tapped for M6x1 fasteners.
Adjustable Caster pill, 3/8 kingpin, half offset-Utilize to change caster and camber on all AC compatible spindle hangers that feature a 3/4" mounting hole. Installing a single pill allows you to change caster or camber by up to .75 degrees. Installing a half offset pill in the top and bottom of the sppindle hanger allows you to change caster by up to 1.5 degrees.
The Brava Cadet/Rookie floor pan is made for use with all chassis models that are 2003 and newer. They are 22 1/8" long and 14 5/8" wide and in a flat black finish.
Made for direct use with the Margay Brava 1.25 chassis, this rear torsion tube will help provide a strong level of grip to the rear end of the kart.
Standard throttle cable used on all karts that utilize a 1/4" rod link to the pedal. Standard equipment on all Pre-1997 Margay karts and also on most oval track karts.
Clamp block for underside of the Wildcat/C1/Ignite K3 pedal clamp block assembly.
Need some extra front end grip? Adding 25mm spindles in place of the standard 17mm spindles is the answer. Machined from billet 86L20 steel then heat-treated to our specifications, our 25mm spindles significantly increase initial turn-in response and overall front grip. A must have for higher horsepower applications.
Machined from billet 6061-T6 aluminum, this TruSpeed steering wheel hub fits a 3/4" diameter shaft (standard on all Margay Brava karts). Two mounting positions allow the driver to fine tune the steering wheel postion for maximum performance. Steering wheel mounting holes are tapped for M6x1 fasteners.
These split bearing cassettes are for the use of 40mm or 50mm axle bearings in the older 3 bolt cassette mounting chassis. They are split at the top to provide adjustable tension on the bearing itself.
This floor pan is made for use with the 2001 Brava Cadet racing chassis and comes in a flat black finish.
This front bumper bracket is made to be used with some of the Margay Racing vintage series chassis. These chassis include: Puma, Lynx, Cougar and the Xpert III.
- per page
Bridgestone Tires-Sales & Closeouts
Accessories
Frame Components
OTK VLR100 Engines
